1, for a long time to use the machine tool, during the long holiday should try not to shut down, you can snap stop.

2. Check the system fan regularly. If it is contaminated with too much oil, it should be replaced or cleaned up.

3. Regularly check the hydraulic oil pressure, liquid level and hydraulic impurities in the hydraulic system to ensure smooth oil circuit.

4. Regularly clean or lubricated components with spring such as switch, tool arm spring and hydraulic valve spring.

5, according to the driver equipment contaminated with oil, regular cleaning.

6, regularly for machine tool replacement system battery, electrical machine tool cabinet replacement desiccant, especially in the long holiday before shutdown, is not to forget this step.

7, after the long holiday, before restarting, to the machine tool each circuit board for artificial preheating, can be used to heat each circuit board for a few minutes, a little temperature can be.

CNC machine tools have a high degree of automation, with high precision, high efficiency and high adaptability, but its operating efficiency, the failure rate of equipment, the length of service life, to a large extent also depends on the user's correct use and maintenance. Good working environment, good use and maintenance, not only will greatly extend the trouble-free working time, improve productivity, but also will reduce the wear of mechanical parts, avoid unnecessary mistakes, greatly reduce the burden of maintenance personnel