In the horizontal machining Heart is suitable for the aerospace, automotive, mold, shipbuilding, electrical, machine tools, printing, textile and machinery manufacturing, mainly used for small to medium sized parts, molds and other processing, a clamping workpiece for completion after milling, drilling, boring, reaming, side and working procedure of processing, processing to realize programmed, shorten the production cycle, Thus the user obtains the good economic benefit.

　　The machine adopts advanced design, processing and manufacturing technology, and is one of the products designed and developed by our company with independent intellectual property rights. The machine adopts mechatronics structure, so that the machine tool mechanism design is more reasonable, machine rigidity, precision retention, reliability. Through the introduction of advanced design concept, scientific design means, to solve the traditional design can not avoid the deficiency, with high precision, high rigidity, high speed and other advantages.

　　The following points should be noted in the use of horizontal processing:

　　1, should be installed away from the source, do not be direct sunlight, no heat radiation and no damp place, if there is a source near the installation environment, should be set up around the processing center shockproof ditch. If you do not set shockproof ditch will directly affect the processing accuracy and stability of the processing center, a long time will affect the electronic components contact bad, failure, affect the reliability of the use of equipment.

　　2, machine tool factory parameter Settings: customers can not change the machine tool factory parameter Settings when using, because these factory parameter Settings are directly related to the dynamic characteristics of each part of the processing center, only the gap compensation parameter value can be set according to the actual situation. If you want to change the factory Settings, you should contact the manufacturer and change the factory Settings under the guidance of the manufacturer's technical personnel.

　　3, strict control: the voltage current is generally installed in processing workshops, and processing workshop equipment is numerous, inevitably lead to power grid volatility, so the installation position should be strictly control the power supply voltage and current, voltage and current of the power supply control within the scope of the permit, be sure to keep the power supply voltage and current is stable, otherwise it will affect the normal work.

　　4, temperature and humidity will directly affect the use of equipment: generally in an environment of less than 30 degrees Celsius can work normally, in general, the distribution box is set with exhaust fans and cooling fans, to ensure that electronic parts and processors are in a constant temperature state of work. If the temperature and humidity are too high, the life of the components in the control system will be reduced, resulting in an increase in faults. If humidity increases, dust will increase on the integrated circuit board resulting in poor contact and short circuit failure.